The first reply to my email asked my to provide several pieces of information, including my email address. The process could have gone a lot faster if they'd actually read my questions. Despite numerous resets following their somewhat bizarre instructions, absolutely nothing worked. This was after a long and fruitless round of email with tech support. Booted up right away to what looked like a firmware screen, and after rebooting, everything was normal. The only thing that was necessary to do is to unplug the logic board (underneath the board at roughly left center) and then plug it in again.
The Mino is close enough to the HD that it wasn't hard to get it apart. I had the same symptoms didn't turn on, flashing white light forever and the drive wouldn't mount. Flip MinoHD Video Camera With Charger 8 GB 2 Hour Record Time 2nd Gen (M2120M) 4.99.
Cisco flip video camera charger manual#
I just managed to fix my Flip Mino (not HD), following the MinoHD manual and Scott's tip above. Cisco Flip Video Ultra HD 3 Model U32120 Black 8 GB Camera Camcorder Read More. I have a few iphone pics of my unit's innards. At any rate, videos from 13 months ago remained in memory and have now been safely off-loaded. I tried that, but am unsure whether it actually reset. There was a frightening moment when first powered on where factory specs were displayed for minute or so, and an option to reset by holding the red button was offered. At any rate, the video from 13 months ago was intact, and 18% battery charge remained. /rebates/2fb2fFlip-Video-Camcorders2f117242fbn68&252fb252fFlip-Video-Camcorders252f11724252fbn6826tc3dbing-&idebay&nameEbay&ra1. I can only conclude it was probably a bad connection or a bad logic state which was corrected by disconnection and reconnection of the internal components. I reassembled the dang thing, and it works fine. The compact adapter plugs into any wall outlet and. When the chips arrived, I opened my MinoHD only to discover it had a substantially different design from the version, and the chip I ordered was not in my design!! The Flip Video Power Adapter helps you keep your Flip video camera charged and ready to go at all times. I looked at the disassembly instructions here at and determined that the first chip near the usb jack (TPD12S521DBTR) was a likely bad component and ordered a couple from for $1.79 each. only to discover that repair would cost as much as a new unit!! Only worthwhile, perhaps, if you have very valuable video trapped in the device's memory. I would add that when I attached the FLIP MinoHD to my computer via its USB jack, the led on the jack blinked continuously, yet the device was not even acknowledged by windows, nor would it power on after sufficient time for a complete charge.Īlso, I tried the reset button hidden in the tripod socket, and called tech.
0 kommentar(er)
